欧美国产日韩另类视频区,2025人妻中文字幕乱码在线,日本三级sm在线观看,小说区图片区另类春色,国产第一浮力影产院路线,欧美亚洲综合图片第一页

xO08R2 1SBP260109R1001 ABB 繼電器輸出擴展模塊

1PLC類型

其中MR為繼電器類型，MT為晶體管類型，它們的區別是:

1.繼電器接的外部電源可以是直流也可以使交流，可直接驅動22v直流負載，晶體管的外部電源只能接直流的，不能直接驅動開關，需要接中繼來間接驅動

⒉.繼電器類型的開關頻率低，而晶體管可以輸出高頻信號如伺服系統的脈沖輸出就使用晶體管類型的PLC。在實際運用中根據需要來選擇相應的PLC規格。

2PLC輸出端子輸出端子介紹

以40端子來說明，輸入3組+輸出2組=5*40揣子，其中輸入端子只有一個公共端S/S，而輸出有5個公共端。YO和V1各單獨使用com端，V2和Y3共用con2，V4、5、6、7共用com3，v10、11.12、13共用com4，Y14、15、16、17共用com5。

3繼電器接線

繼電器類型的PLC輸出回路如下圖，可以使用直流電源和交流電源來驅動負載，不分漏源型輸出。繼電器型PLC輸出回路

工控中常見的輸出控制有電機、指示燈、報警器、電磁閥門等，有個能直接與PLC輸出端子Y連接，有的則需要中間繼電器或者接觸器來連接。

這些閥門的輸出線為兩線制，一根接火線、另一根零線，可直接通過PLC輸出端子與電源相接來控制，一般為了保護PLC需添加中繼進行連接，通過中繼的觸點與電磁閥相連。

輸出與中繼連接

輸出與接觸器連接4晶體管

晶體管類型的PLC的外部電源必須是直流的，有漏型接法．源型接法與輸入的說法剛好相反;晶體管plc輸出

除了外部電源與負載電源一致以外的，其他輸出不能直接與負載相連接，它的輸出端與com斌在沒有輸出的情況下是半導通狀態，接交流負載常導通，這個新手一定注意。它一般通過中繼與負載連接，此時的中繼為直流類型的的，線圈一定主要正負極。

例如MT類型的PLC控制電機，通過24v直流中繼的間接控制接觸器。

總體來說，PLC輸出信號的接法簡單，可以理解PLC的輸出就是線圈的兩個觸點Y和com端，這兩個觸點接負載的兩端即可，我們只要了解PLC的輸出類型與負載類型看是否需要通過中繼來驅動。

1PLC type

Where MR Is the relay type, MT is the transistor type, their difference is:

1. The external power supply connected to the relay can be DC or AC, which can directly drive 22v DC load. The external power supply of the transistor can only be connected to DC, and can not directly drive the switch

The switching frequency of the relay type is low, and the transistor can output high frequency signals such as the pulse output of the servo system using a transistor type PLC. In the actual application according to the need to choose the corresponding PLC specifications.

2PLC Output terminal This section describes the output terminal

To illustrate with 40 terminals, 3 groups of input + 2 groups of output =5*40 rods, in which the input terminal has only one common terminal S/S, and the output has 5 common terminals. YO and V1 use com terminals separately, V2 and Y3 share con2, V4, 5, 6, and 7 share com3, v10, 11.12, and 13 share com4, and Y14, 15, 16, and 17 share com5.

3 Relay Wiring

The PLC output circuit of the relay type is shown below. Dc power supply and AC power supply can be used to drive the load, regardless of drain-source output. Relay type PLC output loop

Common output controls in industrial control include motor, indicator light, alarm, electromagnetic valve, etc., one can be directly connected with PLC output terminal Y, and some need intermediate relays or contactors to connect.

The output line of these valves is two-wire system, one is connected to the live line and the other is neutral line, which can be controlled directly through the PLC output terminal and the power supply. In general, in order to protect the PLC, a trunk needs to be added for connection, and the solenoid valve is connected through the contact of the trunk.

The output connects to the trunk

The output is connected to the contactor with 4 transistors

The external power supply of a transistor type PLC must be DC and have a drain connection. The source type connection is the opposite of the input; Transistor plc output

In addition to the external power supply is consistent with the load power supply, other output can not be directly connected with the load, its output and com bin in the absence of output is semi-conductive state, connected to the AC load normal conduction, this novice must pay attention to. It is generally connected with the load through a trunk, at this time the trunk is DC type, and the coil must be mainly positive and negative.

For example, a PLC of the MT type controls the motor and indirectly controls the contactor through a 24v DC relay.

In general, the PLC output signal connection is simple, it can be understood that the PLC output is the two contacts Y and com end of the coil, the two contacts can be connected to both ends of the load, we only need to understand the PLC output type and load type to see whether it needs to be driven by relay.

*更多關干我們公司的信息

我們大量的工業產品庫存已準備好發貨，這是我們產品的核心。它包含更多超過400，000種電子產品，如PLC，HMI，驅動器，伺服和CNC設備，IPC和PG.

無論是新的還是停產的，從最小的模塊到完整的配置。我們有多年的產品不容易獲得，最新技術和介于兩者之間的所有其他產品。

對市場的洞察力、技術發展和客戶需求使我們能夠戰略性地購買，所以我們很少需要轉移我們的業務。如果商品碰巧缺貨，我們將搜索我們的首選供應商網絡。

*您可能需要的某些零件:07AI91 ABB模擬輸入輸出模塊

SCHROFF MPSO22 13100-203

CTI250O-RBC 901E-250O-RBC

B&R 5AP1130.156C-000

NI GPIB-14OA/2

GE IC695CPU315-BB

ABB CI570 3BSE001440R1

ABSOLUTE API4380-G

FOXBORO FBM230 P0926GU

EMERSON 1C31203G01

ALSTOM V4561983-0100 V4559856

FOXBORO FBM233 PO926GX

ENTERASYS A4H124-24TX PO973JM

HIMA F8650x 984865065

HIMA X-FAN1003 993201013

SCHUMACHER ATCS-15 1464-0320

ABSOLUTE API4380G

HIMA LMO02_MAX 985020002

FOXBORO FBM230 P0926GU

KROHNR OPTIFLUX4300W IFC300w

HIMAX-DI1601 985210222

GE F650-N-F-L-F-2-G-1-HI-P-6E

PROSOFT PTQ-PDPMV1

HIMAX-BLKO1 632590802

Sartorius MDB-8E

*免責聲明:

雄霸銷售工業自動化零件，包括新產品和停產產品，以及購買此類特色產品通過獨立渠道進行。雄霸不是授權經銷商，本網站上特色產品的經銷商或代表。

所有產品名稱/產品圖片，本網站上使用的商標、品牌和徽標是其各自所有者的財產。

帶有這些名稱、圖像、商標、品牌和徽標的產品描述、描述或銷售僅用于識別目的，并不意味著與任何權利持有人有任何從屬關系或授權。